Kenmore INTELLISOFT 420 SERIES 625.38426 - Manual (Page 17)

Install Covers and Restart Water Heater
INSTALL COVERS
After installing your water softener, replace the covers.
Angle the covers so the main cover clips onto the back
first, then bring down in front and clip on the two (2) tabs
inside the rim of the salt hole and lower the salt cover
closed. See Fig. 23.
RESTART THE WATER HEATER
Turn on the gas (or electric) supply to the water heater
and light the pilot.
YOUR PLUMBING INSTALLATION AND ELECTRICAL
WORK ARE NOW COMPLETE.
Cover
(Main)
Salt Hole
Cover
FIG. 23
Program The Timer
Display REGENERATION Button
inteiliSoft
PROGRAM THE TIMER
1. When the transformer is plugged in, a model code
(H46) and a test number (example: G1.1) show in the
face plate display for 4 seconds. Then, 12:00 AM and
PRESENT TIME begin to flash.
NOTE: If “
---- ”
shows in the display, press the UP
or DOWN button until H46 shows in the display.
Then, press the SELECT button to set, and change
to the flashing PRESENT TIME display.
2. To check the model code, unplug the transformer at the
wall outlet and plug in again. If other than H46 shows,
refer to the Troubleshooting Section.
SOUND “BEEPER”: A “beeper” sounds while pressing
buttons for timer setup. One beep signals a change in
the face plate display. Repeated beeps mean the timer
will not accept a change from the button you have
pressed, telling you to use another button. For example,
while setting the hardness the beeper sounds repeated­
ly when the display reaches 1 using the DOWN button,
or the highest hardness setting using the UP button.
FIG. 24
Model: iI46
Version: Gl.l
Thank You
i'or Choosing Kenmore
■or Quality Water
Present Time:
SM—PM
A V CHANGE SELECT
FIG. 25
Questions? Call The Kenmore Water Line 1-800-426-9345
17