Sharp AQUOS LC-37GP1U - Manual (Page 31)

Basic adjustment settings
iPòwèrvGdrìtrdi;
Power control setting allows you to save energy.
No signal off
When set to “Enable”, the power will automatically shut
down If there Is no signal for 15 minutes.
j Press MENU to display the MENU screen, and
* then press < 4 /^ to select “Power Control”.
'ess 4 /V to select “No Signal Off”, and then
press ENTER
;s < 4 /^ to select “Enable”, and then press
NTER.
Five minutes before the power shuts down, the
remaining time displays every minute.
^ress MENU to exit.
I
« “Disable” is the factory preset value.
* When a TV program finishes, this function may not operate.
No operation off
When set to “Enable”, the power will automatically shut
down if there is no operation for 3 hours.
Press MENU to display the MENU screen, and
' then press - 4 /^ to select “Power Control”.
■
:3l
Press a /T to select “No Operation Off”, and
then press ENTER.
Press - 4 /^ to select “Enable”, and then press
ENTER
» Five minutes before the power shuts down, the
remaining time displays every minute.
Press MENU to exit.
■Digital: Bet.ypf'
This setting allows you to optimize the settings of
Digital broadcasting.
■ Audio: Setup
Yoi I rwi I outp'i il. 'digil.'.tl ;ii irlic. hi ,;ii : AV .■■iinptiiiv;r rii'
similar device whose DIGITAL AUDIO INPUT terminal
is connected to the DIGITAL AUDIO OUTPUT terminal
on the TV. Please select an audio output format
compatible with the audio format of the program you
are watching and the equipment connected.
Press MENU to display the MENU screen, and
■ then press -4/^ to select “Digital Setup”.
2
Press £/W to select “Audio Setup”, and then
press
ENTER.
Press A/T to select “PCM” or “Dolby Digital”,
and then press ENTER.
V.-.1 L-VV..-B :i.-.E.li
PCM The optical output terminal outputs audio
signal in PCM form. If your digital audio
system does not support Dolby Digital,
select “PCM”.
Dolby Digital The optical output terminal outputs audio
signal in Dolby Digital form. It reproduces
sound from surround program of digital.
Press MENU to exit.
“Disable" is the factory preset value.
®- 30