Kenwood TM-261A - Manual (Page 32)

6 Press [MR].
• The selected transmit frequency is stored in the
memory channel, and the previous mode is restored.
• Associated data selected in Step 1 such as Tone
status/frequency, the frequency step, and DTSS
status/code are not altered by this step. However,
Transmit Offset status and Reverse status are erased.
• Storing a receive frequency in a split memory channel
erases any previous data in that channel.
Note: After completing each of Steps 2 ~ 5, you must execute the
next step within approximately 10 seconds or the previous mode is
restored.
RECALLING MEMORY CHANNELS
1 Press [MR].
• The memory channel used last is recalled.
2 Turn the Tuning control, or press microphone
[UP]/[DWN], to select the desired memory channel.
• Clockwise or microphone [UP]:
Increases the channel number.
• Counterclockwise or microphone [OWN]:
Decreases the channel number.
• Empty memory channels cannot be recalled.
• If [VFO] is pressed, the VFO mode is restored.
Note:
♦ Memory channels can also be recalled via the microphone keypad.
See "Memory Channel Number Entry” {page 44}.
♦ When a split memory channel is recalled, +" appears on the
Display. Press [REV] to display the transmit frequency.
ERASING MEMORY CHANNELS
Although it is possible to ovenwrite existing data in any of
the memory channels with new data, at times you may
want to ciear data from memory channels without entering
new data. It’s convenient to clear channels no longer used
so you can identify channels that are free for memorizing
new frequencies. Memory channels that contain no data
cannot be recalled while in Memory Recall.
1 Press [MR] to select Memory Recall.
2 Turn the Tuning control, or press microphone
[UP]/[DWN], to select the desired memory channel.
3 Switch OFF the power to the transceiver.
4 Press [MHz]+POWER ON.
• The contents of the selected memory channel are erased.
Note: Memory channel 1 cannot be erased.
26