COMP Cams 1622-16 Ultra Pro Magnum Rocker kit, chrysler 383-400 shaft 1.5 - Manual

COMP Cams®
3406 Democrat Rd.
Memphis, TN 38118
Phone: (901) 795-2400 Fax: (901) 366-1807
www.compcams.com
Part #119
Revised 5/29/08
#1321-16 & #1322-16 Chrysler Pro Magnum™ Rocker Arm Kits
Thank you for choosing COMP Cams® products; we are proud to be your manufacturer of choice.
Please read this instruction sheet carefully before beginning installation, and also take a moment to
review the included limited warranty information.
1. Locate the rocker arms on the rocker shafts similar to the OEM rocker arms. (Note: For Big
Block Chrysler ONLY, Part #1321-16, you should first separate the left side rocker arms
from the right side rocker arms.)
2. Check that the oil holes in the shafts are in the correct down position.
3. The rocker arm dividers are stampings; tolerances are somewhat loose and fitting may be
required to achieve proper clearance between the rocker arms. Minimum clearance should be
approximately 0.030".
4. This rocker arm requires a 5/16" ball-end type pushrod. Check pushrod geometry in all
applications, then refer to the COMP Cams® catalog for the correct part number pushrod.
5. Use OEM recommended torque specifications to secure all hold down bolts and adjusters.
Limited Warranty
Competition Cams, Inc. warrants that all of its products are free from defects in material and workmanship, and against
excessive wear for a period of (1) one year from the date of purchase. This limited warranty shall cover the original
purchaser.
Competition Cams, Inc.’s obligation under this warranty is limited to the repair or replacement of its product. To
make a warranty claim, the part must be returned within (1) one year of purchase to the address listed below, freight
prepaid. Items covered under warranty will be returned to you freight collect.
It is the responsibility of the installer to ensure that all of the components are correct before installation. We assume
no liability for any errors made in tolerances, component selection, or installation.
There is absolutely no warranty on the following:
A) Any parts used in racing applications;
B) Any product that has been physically altered, improperly installed or maintained;
C) Any product used in improper applications, abused, or not used in conjunction with the proper parts.
There are no implied warranties of merchantability or fitness for a particular purpose. There are no warranties,
which extend beyond the description of the face hereof. Competition Cams, Inc. will not be responsible for incidental and
consequential damages, property damage or personal injury damages to the extent permitted by law. Where required by
law, implied warranties or merchantability and fitness are limited for a term of (1) one year from the date of original
purchase.
This warranty gives you specific legal rights and you may also have other legal rights, which vary from state to state.
INSTRUCTIONS