EVCO EVCSR818P9EF - Manual (Page 48)

EVCO S.p.A. Vcolor 818 | Installer manual ver. 1.1 | Code 144VC818E114
page 48 of 94
Output K6 is activated at maximum for the time established with parameter u8 or until the temperature detected by
the needle probe reaches that established with parameter u7; closing the door, i.e. the deactivation of the door micro
switch input causes heating to be cut-off.
The buzzer is activated for 2 s on conclusion of heating.
6.17 Fish sanification
The fish sanification cycle is divided into the following three phases:
- blast chilling
- maintenance
- storage.
On conclusion of a phase, the device passes automatically to the next.
Operate as indicated to start the cycle:
1. Make sure the device is in the "on" status.
2. Make sure that the keyboard is not locked and that no procedure is in progress.
3. Press and release the key AUX (1) and then press and release the key with the icon fish (2).
The device will display the blast chilling end temperature, the work set-point during blast chilling and the duration of
maintenance.