To start the demonstration mode, Easy set, Switching the system on – Philips FW-M55 User Manual
Page 20: Switching the system to standby mode, Selecting the source, Selecting the equalizer display, Sound control, Operating the system
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
speaker wire as shown.
u le n iLui ivc) no I'w.c I ui II
111
ig iwi ig
speaker wires across rooms.You can
place as many remote speakers as you
like provided they operate at the same
rumble oT spaceships, ezc.j. oe sure to
follow the instructions supplied with the
subwoofer
0
OPERATING THE SYSTEM
To start the demonstration mode
• Press and hold ■ {on the system
only) for five seconds
when the
system is in standby mode.
The demonstration will begin.
Easy Set
EASY SET allows you to store all
available radio stations automatically.
• Press and hold
STANDBY ON
(on
the system only) for five seconds
when the system is in standby or
demonstration mode.
” will be displayed,
and followed by'
” and
then"fluTO”.
EASY SET will start searching for
all radio stations on FM band and
then followed by radio stations on
AM band.
— All available radio stations with
sufficient signal strength will be
stored. Up to 40 presets may be
stored.
Notes:
- EASY SET will start with the FM band,
if there are still presets available, the
system will continue to store the AM
band.
- When EASY SET is used, all previously
stored radio stations will be replaced.
- The last preset radio station will
appear on the display when EASY SET
is completed.
Switching the system ON
• Press
CD, TUNER, TAPE
or
AUX
You can also switch on the system by
pressing any one of the DISC DIRECT
PLAY buttons.
Switching the system to
standby mode
• Press
STANDBY ON
or (!) on
the remote control.
The system will switch to standby
mode.
Selecting the Source
• Press the respective source selection
button:
CD, TUNER, TAPE
or
AUX
The display indicates the selected
source.
Note:
- For an external source, make sure you
have connected the audio left and right
OUT terminals of the external
equipment (TV, VCR, Laser Disc player,
DVD player or CD Recorder) to the
AUX/CDR IN terminals.
Selecting the Equalizer
Display
You can select the desired equalizer
display for the system. You must not
press the DSC or INCREDIBLE
SURROUND button on the system
before using the JOG control.
• Adjust the JOG control to select the
desired Equalizer Display, NORMAL,
TOP DOWN, or NITE MODE.
The selected display will be
shown.
NORMAL Display
TOP DOWN Display
PROGRAMSHUfaf
pilpi““ ». A ' , T " 1
•■cAi jAs tinii
NITE MODE Display
Note:
~ In NITE MODE, all lights will be
switched off and the display brightness
will be dimmed.
Sound Control
VOLUME ADJUSTMENT
Adjust
VOLUME
to increase or
decrease the sound level.
For Personal Listening
Connect the headphones plug to the
ij^i socket at the front of the system.
The speakers will be muted.
INCREDIBLE SURROUND
Normal stereo sound is determined by
the distance between the front
speakers. When Incredible Surround is
switched on, it magnifies the virtual
distance between the front speakers for
an incredibly wide, enveloping, stereo
effect.There are 12 different Incredible
Surround levels available for selection.
• Press
INCREDIBLE
SURROUND
to switch on.
The
INCREDIBLE SURROUND
display lights up.
-* “.ib X . X ” w i l l be displayed.
Note:
- "..i .t" is the last selected Incredible
Surround level.