Galaxy Audio RM2 - Manual (Page 5)

RM2 SETUP AND CONNECTIONS
The RM2 setup and connection procedure will always
depend on which modules are installed into the unit and the
peripheral devices connected to it. As a general rule, make sure
all the power switches of all devices are in the off position before
making the power and audio/video connections. Plug the
included AC Adapter into an AC outlet of the specified voltage
and connect it to the DC In Jack on the rear panel. Alternatively
you may supply 12-13.5VDC, 1.5A to the DC In Screw Terminals
on the rear panel. Be sure to observe the correct polarity. Once
all connections are made, make sure all volume controls are set
to the minimum before switching on the devices. Power up the
equipment in the order of signal flow, with the source devices
first (including the RM2), then the mixer and processors, and
finally the power amps last. This will prevent any loud switching
“pops” in the system. The preferred power down order would be
the reverse of this.
RM2 Rack Chassis Specifications
Size: Single full rack space
Capacity: Holds up to 2 Modules
Power Supply: Included AC Adapter
Input: 120 VAC, Output: 12-13.5 VDC, 1.5A
I/O:
RCA Stereo Line Inputs for Recording
Module 1 RCA Stereo Line Output
Module 2 RCA Stereo Line Output
Priority RCA Stereo Line Output
AM/FM Antenna Terminals
Alternate 12-13.5 VDC Power Input (Screw Terminals)