Philips 27ce7695 - Manual (Page 8)

Setting
^POWER^
u
AUDIO ^
A. Radio on the A/V tuner
amplifier
Switching on
• Press the POWER button.
Note: You can switch off the A/V tuner
amplifier by pressing the POWER
button once again.
• Press the TUNER AUDIO button (AM
or FM indication lights up).
• TU followed by a programme number
or only the frequency appears on the
display.
Control panel
• Open the flap by pressing the top
right-hand corner.
Id
MODE SYSTEM
0 o
AUDIO F<P VIDEO
Searching for and storing
radio stations
Important!
Radio stations can be found on the
medium wave (MW) and the FM band
(FM).
The MW band is indicated by AM,
frequency range 522-1611 kHz.
The FM band is indicated by FM,
frequency range 87.50-108.00 MHz.
A programme number is the number
under which you have stored a tuned-in
radio station in the memory. This is
indicated by TU and one or two digits
on the ‘audio/video selection’ display
of the A/V tuner amplifier.
Note: If the frequency is indicated, set
the A/V tuner amplifier in the
programme numbers mode by pressing
the AUDIO F/P button.
• Press the STORE (A) button.
The TU indication starts to flash.
n
i
T DOWN UP k
B.
• Press the SEARCH (B) button.
AM or FM and the frequency will be
displayed, depending on where you are
searching.
If the radio station that has been
located is too weak, or if it is not the
desired station, continue to search by
pressing the SEARCH (B) button again.
Note: When a radio station has been
located, TU will flash again.
When the desired radio station has
been located, select a programme
number.
• Press the T DOWN or UP ▲ button
to select the desired programme
number.
Note: You can give 30 radio stations a
programme number (from 00 to 29).
D.
• Press the EXECUTE (D) button. The
radio station is now stored in the
memory under the programme number
selected by you.
The TU indication does not flash any
more.
Searching for and storing
other radio stations
To search for and store the other radio
stations, repeat operations A, B, C and
D.
Personal sound setting
The sound is already stored in the
memory at a basic level.
After the sound settings have been
changed, this basic level can be reset
by pressing the green PP button on the
remote control unit.
It is possible, however, to change the
basic level according to your personal
preference and to store it in the
memory.
To do this, press the plus -F or minus
— side of the corresponding buttons
(plus at the top, minus at the bottom).
• VOLUME
High notes (5 (TREBLE),