Jaypro Sports FBGP-920AX - Manual (Page 12)

WWW.JAYPRO.COM P a g e 12 11/1/13
1. Insert one end fitting into one end of the crossbar.
a. It is recommended that you lubricate the end fitting and the inside of the
crossbar with white lithium grease.
2. Rotate end fitting such that the upright insert is pointing downward at about a
45-degree angle.
3. Lift one upright over the upright insert on the end fitting.
4. Install a 1/2-13 x 5-inch bolt, a 1/2” washer and 1/2-13 nut in through the upright
and pre-drilled hole in the upright insert.
5. Rotate the end fitting until the upright is vertical and install the anti rotational
bolt in the crossbar along with the 1/4-20 x ¼ in set screw to lock it in position
(See Figure 9). It is recommended that you use an Antiseize Lubricant on both
the anti rotation bolt and the set screw.
6. The end fittings are adjustable, spaced 23’-4’’ between uprights for High School
play and 18’-6’’ between uprights for College play. Start by inserting the end
fitting into the crossbar to the College position measuring 5 inches between the
inside on the upright to the outer edge of the Crossbar.(see Figure 8). This
should give you 18’-6’’ between the inside edges of both uprights suitable for
College play.
a. Again it is recommended that the end fitting and the inside of the
crossbar be lubricated with white lithium grease.
b. Use a rubber mallet if necessary to move the upright in or out as
needed.
7. Plumb the upright/end fitting in two directions: front to back (perpendicular to
goal line) and side to side (parallel to goal line).
a. Use the two set screws in the upright to adjust and maintain the plumb
of the upright in the direction parallel to the goal line (DO NOT DRILL
HOLE IN UPRIGHT INSERT YET).
8. Drill a 1/2” hole in end fitting using the hole in the crossbar closest to the
gooseneck as a guide.
a. Use of a 17/32” transfer punch to center hole is strongly recommended.
b. It is recommended that you pilot the hole with a 3/16” bit, step up to a
3/8” bit and finish with a 1/2” bit.
c. To ensure proper alignment of holes, do not try to drill all the way
through both faces of end fitting at once. Instead drill from each side of
end fitting and check for plumb after each drilling operation.