Muse Research Receptor VIP manual v1.1 - Manual (Page 18)

18
The MIX Button and Adjusting Levels
The MIX section allows you to adjust the volume and panning of the main outputs, adjust the
channel volume on any of the synth or effect slots, as well as configuring insert or send effects
using their factory presets.This is done by pressing the MIX button on the front panel.
When you are in PLAY mode, pressing the MIX button lets you adjust or see the following:
Master Volume: Adjust the main output mixer volume.
Master Pan: Adjust the left or right panning of the main output.
Main Output Meters: View the output levels on separate L and R meters.
When you select either the SYNTH or EFFECT button along with the MIX button, you can adjust the
following:
Adjust Volume for any Synth or Effect Channel (using the Channel +/- buttons)
Adjust Panning forany Synth or Effect Channel (using the Channel +/- buttons)
View the Output Meters for any Synth or Effect Channel (using the Channel +/- buttons)
Adding Effects to your Main Mix
With the MIX button pressed, you can also load two separate effects into the mixer channel,
allowing you to perform additional processing on any source, whether it is a synth or an audio
input. This works just like the Synth and Effect channels, letting you select a Tag, and load a
preset. For example, we can navigate to the FX REVERB tag and load up a reverb effect.
There are two Mixer effects slots in your RECEPTOR VIP. They can be configured as "Insert" effects,
where all the audio goes through the effect on the way to the outputs, or as "Send" effects, where
you can control on amount of the effect you want to have on a channel-by-channel basis.