Muse Research Receptor VIP manual v1.1 - Manual (Page 32)

32
System Specifications
Dimensions: 19" wide (one rack space, (48cm)), 3.0" high (not including feet, two rack spaces (7.6cm)), 10.5" deep
(26.7cm), not including knobs. RECEPTOR VIP is designed for table-top and rackmount use.
Weight: RECEPTOR VIP weighs approximately 15 lbs (6.8kg).
Power Requirements: 100-240VAC input, 50/60Hz, 2A Max, auto-power ranging. Can be used anywhere in the
world with the proper power connector. If the power feeding this device is subject to brownouts or interruption, we
recommend connecting it to an uninterruptible power supply that can supply 250 watts of power.
Operational Guidelines: RECEPTOR VIP is designed for the rigors of the touring evironment, however we recommend
the following operational conditions to ensure maximum reliability and longevity: The system can operate from 35
degrees F to 95 degress F. If required, you can operate it between 32 degrees F to 110 degrees F. Operation at
extreme temperatures is not recommended for extended periods of time; provide supplemental cooling if required.
When the unit is powered on, the standard hard drive is vulnerable to mechanical failure if subjected sudden
acceleration. For applications where unit will be installed on moving stages, or motor vehicles, or at extremely low
temperatures, we highly recommend installing the optional Solid State Hard Drive which has no moving parts.
Transportation temperature range: -20 to 140 degrees F, assuming unit is not subjected to condensation.
Inputs and outputs:
Front panel:
Two combination XLR/ 1/4" inputs with high-Z instrument input on 1/4" inputs, and low-Z Microphone input
on XLR-type jacks, Pin 2 positive, with 48V phantom power selectable via push-button switch.
One 1/4" TRS (Tip / Ring / Sleeve) headphone jack.
Rear Panel:
Two 1/4" line level outputs, low impedance.
Two 1/4" line level balanced inputs, high impedance.
One full-size 5-pin DIN MIDI INPUT jack.
One 1/4" TRS Footswitch Input jack. grounding the Tip or Sleeve will invoke assigned function. Default
function assignment is Tip=Patch Increment, Ring= Patch Decrement)
Four USB 2.0 Jacks for conection to a mouse, keyboard, or device-compliant MIDI USB devices.
One gigabit Ethernet Jack for connection to a Computer or network (networking cables not supplied).
One 15-pin VgA monitor connector for connecting a computer monitor. Note the DVI port is inactive.
Bottom Panel:
USB dongle port for installing an iLok dongle inside the unit. Port ships disconnected, see website for
instructions on how to activate this port, which requires deactivating the front panel USB port.
Special Front Panel Key Combinations & Shortcuts
Pressing the power button once will cause the unit to start up
Pressing the power button twice will cause the unit to shut down completely. IMPORTANT: ALWAYS SHUT
THE RECEPTOR VIP DOWN BY PRESSINg THE POWER BUTTON TWICE TO ENSURE NORMAL OPERATION.
Pressing the power button three times will reset the unit and reload the current sounds or effects.
Holding down 'PLAY' at startup will rescan Banks and Patches, rebuilds the plugin list, and start the mixer in
a default setting with no sounds or effects loaded.