Muse Research Receptor manual v1.2 - Manual (Page 64)

5: View Buttons in Depth 64 Receptor Manual
The bank’s name is flashing, indicating you must press the bottom display knob to apply the selection. Select a
bank and press the bottom display knob.
S U V i e w B a n k M S B / L S B < >
III III 0 2 4 / 0 0 3 ( m o r e b a n k s )
The bank’s MSB and LSB numbers are displayed. These are the numbers you would enter in your MIDI
sequencer or MIDI control surface to select this bank via MIDI program change.
In addition, the
(more banks) text will be flashing. If you press the lower display knob, you return to the
Bank Type screen where you can select other banks for which you wish to view the MSB/LSB assignments.
S U V i e w B a n k M S B / L S B < >
III III L o u n g e L i z a r d
SETUP: TCP/IP Setup
Rotate the top display knob to select the TCP/IP Setup parameter. Use this parameter if you want to switch
between manual or automatic IP addressing, or if you plan to use a crossover network. This is a multi-step
parameter, since changing TCP/IP setups requires setting multiple parameters.
S U T C P / I P S e t u p < >
III III A u t o ( D H C P )
Rotate the lower display knob to select between three choices: Auto (DHCP) ; Manual ; and Crossover . These
are described further in the following sections.
NOTE: TCP/IP Setup is a global parameter and is not saved with a Multi Patch.
Using Auto (DHCP) Addressing
This is the default option. Select it if you are connecting Receptor to a network that has a cable/DSL modem
or Ethernet Switcher that acts as a DHCP server. Most such devices are configured to provide IP addresses to
network devices.
To use “Auto (DHCP)” addressing:
1 Rotate the bottom display knob to select Auto (DHCP), then press the knob to apply your selection.
You’ll be asked to confirm whether you want to make this change (Yes or No).
2 Rotate the bottom display knob to select Yes, then press the knob to apply your selection.
Receptor will update your TCP/IP settings — a process that will take a few seconds.
3 If you are switching to Auto (DHCP) from either Manual or Crossover modes, you must shut down your
Receptor and restart it before the settings take effect.
Receptor will now use an IP Address provided by a DHCP server. To see this address, rotate the top display
knob until the top line displays
TCP/IP Address . The bottom line will then show the IP address used by
Receptor.
For more information about networking setups and Receptor, see Chapter 12, “Connecting Receptor to a
Computer.”
Using Manual IP Addressing
Select this option if you want to manually assign an IP address to Receptor. To do so:
1 Rotate the bottom display knob to select Manual, then press the knob to apply your selection.
You’ll next be asked to enter the desired IP Address. The IP Address is displayed in 4-blocks of 3-digit numbers. The
cursor is under the left-most block and the text is blinking.