3 input module – NORAC UC5-BC-HG06 User Manual
Page 21
Advertising
18
7.3
Input Module
1. Install the input module (E03) onto the bracket near the NORAC valve block. Secure it to
the boom using cable ties or optional brackets.
2. Connect the free end of the CANbus cable (C08) from the valve module to the input
module. Connect cable C05 to the other CANbus connector and route to the 8-way
coupler.
3. Connect the 12-pin connectors on the interface cable (C20) to the Thru 2 connector and
the Thru 1 connector on the sides of the input module.
Figure 18: Input Module Connections
4. Connect the 12-pin plug on C20 to the 12-pin receptacle on C10.
5. Connect the 12-pin receptacle on C20 to the Hagie interface connection.
Advertising