Curtis Mathes BLU-RAY DISC CMMBX72 - Manual (Page 35)

SYSTEM INFORMATION
When the firmware upgrade is done, check the firmware
details by following the steps below.
1. With the unit in Stop mode, press the SETUP button.
2. Press the buttons to select System Upgrade, then
press the ENTER or button.
3. Press the buttons to select System Information,
then press the ENTER or button.
You can see detailed information about the current
firmware.
If DHCP is set to On, you can't select IP Address, Subnet
Mask or Gateway.
If DNS is set to Automatic, you can't select Primary /
Secondary DNS.
・
・
System setup
Input password
Press Enter the to view software version
Input password
Reset Settings
Update Firmware
Software Version
Press Enter the to view software version
Reset Settings
Update Firmware
Software Version
Software Version
Input password
General
Video
Audio
Language
Parental
Reset Settings
Update Firmware
Software Version
SMP8634_2.0-RC1.2 blue_GCC4_mips
bdtoolkit_20080512
R2.0RC1.1-BD_282_18
SMP8634_BD_282_18GCC4_dev.mips
Press Enter the to view software version
Software Version
33
General
Video
Audio
Language
Parental
OK Cancel
Input password
Password
Reset Settings
Update Firmware
Software Version
General
Video
Audio
Language
Parental
General
Video
Audio
Language
Parental