SkyHunter406 SKYHUNTER 406 HF - Manual (Page 30)

MANL:INS:SH:X:XX August 8 ,2013
Rev 25
6-12
7. The remote connector is ready to be connected to the ELT unit.
8. Pull the panel end of the shielded remote cable through the prepared panel hole. Dress
and insert the wires into the remote switch male connector as shown in the Pre wired
Remote Switch Installation Diagram, part # REMT:INS:SH:X:PR, found in SECTION 6.
Press the male connector until closed. Insert into the Remote Rocker Switch Assembly