Step 8 – hood end panel, Step 9 – screen clips, Step 7 – hood panels – Twin City Modular Gravity Hood - MGR, MGI - IM-4720NFL User Manual
Page 4
Step 8 – Hood End Panel
Fasteners (Kit #4A or #4B or #4C) –
Note: There may be extra fasteners.
Install
Female End Panel Assembly using #12 screws. Fully tighten the Hood Mount Bar/Side Rail fasteners from Step 5.
End Panel Assembly
-Female-
Figure 10.
Step 9 – Screen Clips
Rotate
Screen Clips on End Panel Assembly to support the bird screen.
Screen Clip
#12 Screw
Figure 11.
Step 7 – Hood Panels
Fasteners (Kit #4A or #4B or #4C and Kit #5)
Install
Hood Panels using #12 screws. Place female end of next panel over male end of end panel. See Detail A.
On sizes where hood width is 108" and larger, hood clips must be installed at each interlocking rib while installing
the panels. Position the
Hood Panel in place and reach underneath to slide the Hood Clip into place. See Detail B.
A
Hood Panel
Hood
Width
Figure 9.
Male
Female
DETAIL A
Hood Clip
Female
Male
NOTE: Use Hood Clips on Hood Panels 108" and wider.
DETAIL B
TWIN CITY FAN & BLOWER | WWW.TCF.COM
5959 Trenton Lane N | Minneapolis, MN 55442 | Phone: 763-551-7600 | Fax: 763-551-7601