5 options for data transmission to the usb-b (pc), Interface and the usb-a (usb printer) interface – YSI MultiLab 4010-3 User Manual
Page 110
Transmitting data
MultiLab 4010-3
110
ba76143e03
08/2013
12.5 Options for data transmission to the USB-B (PC)
interface and the USB-A (USB printer) interface
Via the USB-B interface you can transmit data to a PC.
Via the USB-A interface, you can transmit data to a USB printer or USB mem-
ory device. How to transmit data to a USB memory device is described in an
extra section (see section 12.6 D
The following table shows which data are transmitted to the interface in which
way:
Data
Control
Operation / description
Current
measured
values of all
connected
sensors
Manual
With <PRT>.
Simultaneously with every manual data storage process (see
section 11.1 M
Automatic, at
intervals
With <PRT_>.
Then you can set the transmission interval.
Simultaneously with every automatic data storage process (see
section 11.2 A
Stored mea-
sured values
Manual
Displayed dataset with <PRT> after calling up from the storage.
All datasets with the Output to RS232/USB function.
(see section 11.3.1 E
All datasets with the Output to USB flash drive or printer function
(USB-A interface)
For details, see section
Calibration
records
Manual
Displayed calibration record with
<PRT> (see section 5.2.6 C
All calibration records with the Output to USB flash drive or
printer function.
All calibration records with <PRT
_>.
For details, see section
Automatic
At the end of a calibration procedure.
The following rule applies: With the exception of the menus, shortly
pressing the <PRT> key generally outputs the display contents to
the interface (displayed measured values, measurement datasets,
calibration records).