Sears 113.21371 User Manual
Sears, 1/2 inch drill press, Owners manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Sears
owners
manual
MODEL NO.
113.21371
DRILL PRESS ONLY
113.213710
DRILL PRESS WITH
1/2 HP MOTOR
Serial
Number................ ............ ......
Model and serial
number may be found
at the rear of the head.
You should record both
model and serial number
in a safe place for
future use.
CAUTION:
Read GENERAL
and ADDITIONAL
SAFETY
INSTRUCTIONS
carefully
■ ï}tÎEBE5r?s^^iT4Îi®*>r
1
i* ^ iî
lïîjiJ&Sii
CRRFT5MRN.
15-1/2 INCH
DRILL PRESS
•
assembly
•
operating
•
repair parts
Sold by SEARS, ROEBUCK AND CO., Chicago, IL 60684
U.S.A.
Part No. 71189
Advertising
Table of contents
Document Outline
- Sears
- FULL ОМЕ YEAR WARRANTY ON CRAFTSMAN DRILL PRESS
- If within one year from the date of purchase, this Craftsman Drill Press fails due to a defect in material or workmanship, Sears will repair it, free of charge.
- WARRANTY SERVICE IS AVAILABLE BY SIMPLY CONTACTING THE NEAREST SEARS STORE OR SERVICE CENTER THROUGHOUT THE UNITED STATES.
- This warranty gives you specific legal rights, and you may also have other rights which vary from state to
- 1. KNOW YOUR POWER TOOL
- 2. GROUND ALL TOOLS
- 3. KEEP GUARDS IN PLACE
- 4. REMOVE ADJUSTING KEYS AND WRENCHES
- 5. KEEP WORK AREA CLEAN
- 6. AVOID DANGEROUS ENVIRONMENT
- 7. KEEP CHILDREN AWAY
- 8. MAKE WORKSHOP KID-PROOF
- 9. DON'T FORCE TOOL
- 10. USE RIGHT TOOL
- 11. WEAR PROPER APPAREL
- 12. USE SAFETY GOGGLES (Head Protection)
- 13. SECURE WORK
- 14. DON'T OVERREACH
- 15. MAINTAIN TOOLS WITH CARE
- 16. DISCONNECT TOOLS
- 17. AVOID ACCIDENTAL STARTING
- 18. USE RECOMMENDED ACCESSORIES
- 19. NEVER STAND ON TOOL
- 20. CHECK DAMAGED PARTS
- 21. DIRECTION OF FEED
- 22. NEVER LEAVE TOOL RUNNING UNATTENDED
- MOTOR SPECIFICATIONS
- CONNECTING TO POWER SOURCE OUTLET
- WARNING: FOR YOUR OWN SAFETY, NEVER
- CONNECT PLUG TO POWER SOURCE OUTLET UNTIL ALL ASSEMBLY STEPS ARE COMPLETED.
- INSTALLING THE CHUCK
- INSTALLING FEED HANDLES
- INSTALLING THE DEPTH STOP
- RAISING THE HEAD
- INSTALLING MOTOR PULLEY
- INSTALLING AND TENSIONING BELT
- INSTALLING LIGHT BULB
- CHUCK LOCKING COLLAR
- DRILLING TO DEPTH
- ANOTHER WAY-
- WARNING: FOR YOUR OWN SAFETY, ALWAYS OBSERVE THE FOLLOWING SAFETY PRECAUTIONS.
- INSTALLING DRILLS
- POSITIONING TABLE AND WORKPIECE
- HOLE LOCATION
- TABLE AND HEAD LOCK HANDLES
- BELT TENSION
- Always order by Part Number - not by Key Number
- ■o
- FULL ОМЕ YEAR WARRANTY ON CRAFTSMAN DRILL PRESS
- Sears