SINGER 1500 Izek User Manual
Page 22
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(TEST SEWING)
7. Start the machine.
Guide the fabric gently with your hand.
8. When reaching the edge of the material, stop the
machine.
RE-STflRT TO CONTINUE!
$EUING
0
PATTERN NO.
A-005
► MODIFY
ADD TO FAUORITES
RETURN
B
:
-s;
At this point, push the (▼)
Control Pad to select]^ .
a
|
<3 O C>|
Push the A Button
^.xxxx MENU
► PATTERNS
BUnONHOLES
LETTERS
FAUORITES
CUSTOM
COLORS
The menu selection screen
will be displayed again. This
completes the test sewing.
Error message during setting-up
CHECK FLASHING
AREA AND START
$EMING.llflCHINE
If the sewing machine is not set up correctly, the above
message will be displayed when starting the machine.
1. Push A Button.
2. The error message will be displayed. Fix the problem
following the instructions in the message. (Refer to page
67.)
3. When the error has been cleared, screen 6-12 (page
19) will be displayed.
4. Start the machine.
* The start/stop switch on the sewing machine will flash
red for 2 - 3 seconds and will then change to green.
However, the sewing machine will not start again until
the cause of the error has been properly cleared, even if
you try to start the machine, so make sure that you clear
the cause of the error properly.
9. First turn the handwheel toward you until the needle
is at its highest position, then raise the presser foot,
draw material to the rear and cut off excess thread
with the thread cutter located on the bottom of face
cover as shown.
SO