Maytag MC2 User Manual
Maytag, Installation/operator’s manual
Advertising
Table of contents
Document Outline
- Retain This Manual In A Safe Place For Future Reference
- Important
- IMPORTANT
- CAUTION
- CAUTION
- WARNING
- WARNING
- FOR YOUR SAFETY
- IMPORTANT
- Table of Contents
- SECTION I
- SECTION II
- SECTION III
- INSTALLATION PROCEDURES
- A. UNPACKING/SETTING UP
- B. LOCATION OF THE DRYER
- C. DRYER ENCLOSURE REQUIREMENTS
- D. FRESH AIR SUPPLY
- E. EXHAUST REQUIREMENTS
- F. ELECTRICAL INFORMATION
- IMPORTANT: Failure to comply with these codes or ordinances, and/or the requirements
- stipulated in this manual, can result in PERSONAL INJURY or COMPONENT FAILURE.
- NOTE: Component failure due to improper installation VOIDS THE WARRANTY.
- NOTE: The use of aluminum wire VOIDS THE WARRANTY.
- I NOTE: For 100 lb. model, a no. 12 minimum separate ground wire should be used.
- IMPORTANT: For personal safety and proper operation, the dryer must be grounded.
- G. GAS INFORMATION
- H. PREPARATION FOR OPERATION
- L PREOPERATIONAL TESTS
- NOTE: Water column pressure requirements as measured at the gas valve pressure tap are:
- Natural Gas L.P. Gas
- 4 inches W.C.
- 11 inches W.C.
- IMPORTANT: The dryer tumbler (basket/drum) is treated with a protective coating. We suggest tumbling old clothes or material in the basket using a mild detergent to remove coating.
- INSTALLATION PROCEDURES
- SECTION IV
- SECTION V
- SECTION VI
- SECTION VII