Assembly and installation, Install mower deck onto tractor, A warning – Troy-Bilt 14094 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Section 2
Assembly and Installation
Install Mower Deck onto Tractor
1.
Secure each gage wheel assembly (X,
Fig. 1) to mower deck with clevis pin
and cotter spring.
2.
Slide mower deck under tractor.
3.
Attach front lift rods (A, Figs. 1 & 2) to
mower deck as illustrated. Lift rods
are not inter-changeable. Short bent
ends face to the outside of mower
deck and must be installed as
illustrated in Figs. 1 and 2.
A WARNING
LOCK LIFT LEVER DOWN WHEN
SECURING LIFT BRACKETS TO LIFT
LINKS. LIFT LINK IS SPRING LOADED!
POSSIBLE INJURY FROM SCISSOR
ACTION OF LIFT LINK MAY RESULT!
4.
Secure lift brackets (D) (on deck) to lift
links (E) (on tractor) as follows:
a.
Raise lift arm (E) and turn height
adjustment knob in the (-)
direction to lowest setting. (See
inset, Fig. 6, page 9)
b.
Lower and lock attachment lift
lever into down position.
See
page 9, "Raise or Lower Mower
Deck" for locking instructions.
c.
Line up holes on lift bracket (D,
Figs. 1 and 2) with hole on lift link
(E). Insert clevis pin (F) through
lift bracket first, then through lift
link. Secure with hitch pin.
Repeat on other side.
5.
Attach front lift rods (A) to front hitch
points (B) on tractor, over studs.
Secure with click pins (C).
6.
Secure drive belt (G) to tractor PTO
sheave (H).