Aiwa XR-M1000 - Manual (Page 28)

6 Press •REC/REC MUTE to start recording on the
first side.
The tape is rewound to the beginning of the front side, the
iead segment is played through for 10 seconds, and recording
starts. When recording on the front (side A) ends, recording
on the back (side B) starts.
To stop recording
Press ISTOP on the cassette deck or on the CD piayer (or
■ CLEAR on the remote controi). Recording and CD piay stop
simuitaneousiy.
To clear the edit program
Press BSTOP twice on the CD player (or ■ CLEAR twice on
the remote controi) in stop mode so that the highlighted indicator
“EDIT” on the display disappears.
To check the order of the programmed track numbers
Before recording, press EDIT/CHECK on the remote controi to
select a side, and press ◄◄ or ►► on the CD player repeatedly.
The Al edit recording function enabies CD recording without
worrying about tape iength and track length. When a CD is
inserted, the unit automaticaily calculates the total track length.
If necessary, the order of tracks is rearranged so that no track is
cut short.
(Ai: Artificial Intelligence)
Track number Programmed track numbers
Program number
Al edit recording wiii not start from a point haifway into the tape.
The tape must be recorded from the beginning of either side.
1 Insert the tape into deck 2, and press DOLBY NR
to turn Dolby NR on or off.
Insert the tape with the side to be recorded on first facing out
from the unit.
2 Press CD on the stereo receiver and load the
disc(s).
3 Press EDIT/CHECK on the remote control once.
“EDiT” and “Ai” are highiighted.
Ai
I
EDiT
I
• When “PRGM” is highlighted, press EDIT/CHECK again.
4 Press DISC DIRECT PLAY 1-3 to select a disc.
5 Press numbered buttons 0-9 on the remote
control to designate the tape length.
10 to 99 minutes can be specified.
Example: When using'a 60-minute tape, press 6 and 0.
In a few seconds, the tracks to be recorded on each side of
the tape are determined.
is aiso avaiiabie to designate the tape iength.
Remaining time Programmed
of recording tracks for side A Tape iength
■ . • ■
■■■■ ''-
L i >—
j LJ - D O
Tape side
a: First recording side (side A)
b: Second recording side (side
B)
To add tracks from other discs to the edit program
If there is any time remaining on the tape after step 5, you can
add tracks from other discs in the CD compartment.
1 Press EDIT/CHECK on the remote controi to seiect a side.
2 Press DISC DIRECT PLAY 1-3 to select a disc.
3 Press the numbered buttons on the remote controi to seiect
tracks.
A track whose piaying time is longer than the remaining time
cannot be programmed.
4 Repeat steps 2 and 3 to add more tracks.
Time on cassette tapes and editing time
The actuai cassette recording time is usuaiiy a littie ionger than
the specified recording time printed on the iabei. This unit can
program tracks to use the extra time. When the total recording
time is a littie ionger than the tape’s specified recording time
after editing, the dispiay shows the extra time (without a minus
mark), instead of the time remaining on the tape (with the minus
mark).
' The Ai edit recording function cannot be used with discs
containing 31 tracks or more.
' Recording is inhibited if the erasure prevention tab on either
side of the tape is broken off.
28
ENGLISH