Important safety instructions – dbx Pro 480 User Manual

Page 2

Advertising
background image

WARNING FOR YOUR PROTECTION

PLEASE READ THE FOLLOWING:

KEEP THESE INSTRUCTIONS

HEED ALL WARNINGS

FOLLOW ALL INSTRUCTIONS

CLEAN ONLY WITH A DAMP CLOTH.

DO NOT BLOCK ANY OF THE VENTILATION OPENINGS. INSTALL
IN ACCORDANCE WITH THE MANUFACTURERS INSTRUC-
TIONS.

DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIA-
TORS, HEAT REGISTERS, STOVES; OR OTHER APPARATUS
(INCLUDING AMPLIFIERS) THAT PRODUCE HEAT.

ONLY USE ATTACHMENTS/ACCESSORIES SPECIFIED BY THE
MANUFACTURER.

UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR
WHEN UNUSED FOR LONG PERIODS OF TIME.

WATER AND MOISTURE: Appliance should not be used near
water (e.g. near a bathtub, washbowl, kitchen sink, laundry tub,
in a wet basement, or near a swimming pool, etc). Care should
be taken so that objects do not fall and liquids are not spilled into
the enclosure through openings.

POWER SOURCES: The appliance should be connected to a
power supply only of the type described in the operating instruc-
tions or as marked on the appliance.

GROUNDING OR POLARIZATION: Precautions should be taken
so that the grounding or polarization means of an appliance is
not defeated.

POWER CORD PROTECTION: Power supply cords should be
routed so that they are not likely to be walked on or pinched by
items placed upon or against them, paying particular attention to
cords at plugs, convenience receptacles, and the point where
they exit from the appliance.

SERVICING: To reduce the risk of fire or electric shock, the user
should not attempt to service the appliance beyond that
described in the operating instructions. All other servicing
should be referred to qualified service personnel.

FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE
RECEPTACLE:

Replace fuse with same type and rating only.

MULTIPLE-INPUT VOLTAGE: This equipment may require the use
of a different line cord, attachment plug, or both, depending on
the available power source at installation. Connect this equip-
ment only to the power source indicated on the equipment rear
panel. To reduce the risk of fire or electric shock, refer servicing
to qualified service personnel or equivalent.

SAFETY INSTRUCTIONS

NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER

CORD.

WARNING: THIS APPLIANCE MUST BE EARTHED.

CAUTION: EQUIPMENT IS NOT DISCONNECTED FROM MAINS WHEN
SWITCH IS IN THE OFF POSITION

The cores in the mains lead are coloured in accordance with the following

code:

GREEN and YELLOW - Earth BLUE - Neutral BROWN - Live

As colours of the cores in the mains lead of this appliance may not corre-

spond with the coloured markings identifying the terminals in your plug, pro-

ceed as follows:

• The core which is coloured green and yellow must be connected to the

terminal in the plug marked with the letter E, or with the earth symbol,

or coloured green, or green and yellow.

• The core which is coloured blue must be connected to the terminal

marked N or coloured black.

• The core which is coloured brown must be connected to the terminal

marked L or coloured red.

This equipment may require the use of a different line cord, attachment plug,
or both, depending on the available power source at installation. If the attach-
ment plug needs to be changed, refer servicing to qualified service personnel
who should refer to the table below. The green/yellow wire shall be connect-
ed directly to the units chassis.

WARNING: If the ground is defeated, certain fault conditions in the unit or in
the system to which it is connected can result in full line voltage between
chassis and earth ground. Severe injury or death can then result if the chas-
sis and earth ground are touched simultaneously.

LIVE

E

NEUTRAL

EARTH GND

CONDUCTOR

L

N

BROWN

BLUE

GREEN/YEL

BLACK

Normal

Alt

WIRE COLOR

WHITE

GREEN

The symbols shown above are internationally accepted symbols that
warn of potential hazards with electrical products. The lightning flash
with arrowpoint in an equilateral triangle means that there are dangerous
voltages present within the unit. The exclamation point in an equilateral
triangle indicates that it is necessary for the user to refer to the owner’s
manual.

These symbols warn that there are no user serviceable parts inside the
unit. Do not open the unit. Do not attempt to service the unit yourself.
Refer all servicing to qualified personnel. Opening the chassis for any
reason will void the manufacturer’s warranty. Do not get the unit wet. If
liquid is spilled on the unit, shut it off immediately and take it to a deal-
er for service. Disconnect the unit during storms to prevent damage.

C A U T I O N

A T T E N T I O N :

R I S Q U E D E C H O C E L E C T R I Q U E - N E P A S O U V R I R

W A R N I N G :

T O R E D U C E T H E R I S K O F F I R E O R E L E C T R I C

S H O C K D O N O T E X P O S E T H I S E Q U I P M E N T T O R A I N O R M O I S T U R E

R I S K O F E L E C T R I C S H O C K

D O N O T O P E N

IMPORTANT SAFETY INSTRUCTIONS

Advertising