dbx Pro 480 - Manual (Page 99)

®
Receive One Program (42h)
SYS_HEAD 42(h), vv(1)1, vv(1)2, vv(2)1, vv(2)2, xx1, xx2, yy1, yy2, zz(1)1, zz(1)2, zz(2)1, zz(2)2, dd(1st)1,dd(1st)2,
dd(nth)1, dd(nth)2, F7(h)
vv .program dump version number
When xx = 00(h)
Program Bank: 00(h) = User Program
When xx = 01(h) Program Bank: 01(h) = Factory Programs
yy The program number, 1-100 (00-63h)
zz Byte Count
dd(n) Program data
The Receive One Program procedure is used to load a Program into the 480, 482 or 480R. The number of program bytes
to be received (n) is different for each program. If the 480 is sent a Receive One program procedure where the program
number is not a valid RAM destination, it will be ignored.
Receive Bulk Dump (48h)
SYS_HEAD 48(h), dd(1st)1 dd(1st)2, ... dd(nth)1, dd(nth)2, F7(h)
dd(n) Bulk Dump Data
The Receive Bulk Dump procedure is used to load all User Programs into the 480. A software version number is
imbedded in the data.
A.1.3 SYSEX Setup Dump Sample
Following is a simple example of a SYSEX Program dump. It takes you set by step through all of the operation com-
mands of a typical SYSEX procedure.
<<SYSEX Header>>
F0 00 01 1E 7F 03
<<Procedure>>
42
Appendix A
DriveRack ™
DriveRack™ User Manual 91