DaySequerra M4FM - Manual (Page 18)

18
M4FM User Manual
Figure 15.
DHCP is set to ‘ON’ by default. Disabling DHCP allows the users to manually enter an IP, Subnet and
Gateway. Exiting this menu will save and reset the M4FM if a change has been made to DHCP. The
new manual IP address will be displayed on the LCD homescreen
Enter selection mode and toggle the arrow to IP, Subnet or Gateway and press the ENTER button
once. The first field (3 digits) will start to flash. Use the arrow buttons to change up or down within the
allowed range. Press ENTER after each field to save and move to the next field. Pressing ENTER
after the last field saves all changes. The arrow will stop flashing indicating it is in selection mode.
Toggle Exit with the arrow and press ENTER to exit to the previous menu. Once a change has been
made the unit will reset and automatically restart.
About
A Read-Only menu displaying the HDRadio, DSP, and Firmware version.
The selection mode arrow is defaulted to the top right corner of the menu. To Exit press ENTER. More
ABOUT details can be viewed in the Settings tab of the WebServer.
Figure 16.
Exit
Located at the top right corner of the Alarm menu is used to exit back to the previous SYSTEM menu.
From Alarms menu press the UP arrow button until the arrow is to the right of EXIT on the LCD then
press ENTER to exit.