Specifications – Hatteland Display 23 inch - JH 23T14 MMD User Manual
Page 56
![background image](/manuals/737777/56/background.png)
56
IND100129-124
All specifications are subject to change without prior notice!
Specifications - JH 19T14 MMD-xxx-Sxxx (CCFL, Slim version)
2/2
SPECIFICATIONS
Note: All specifi cations are subject to change without prior notice!
Please visit www.hatteland-display.com for the latest electronic version.
Available factory standard cables, 30cm [11.81"] in length.
• VSD100692-1
: 1 x 9P D-SUB (female) - RS-232 (COM1)
• VSD100692-3
: 1 x 9P D-SUB (female) - RS-232 (COM1)
: 1 x 9P D-SUB (female) - RS-232 (COM Touch Screen)
: 3 x BNC (female) (Composite Video in)
• VSD100692-4
: 1 x 9P D-SUB (female) - RS-232 (COM1)
: 3 x BNC (female) (Composite Video in)
Customized cables are possible to support more built-in signals, like: RS-485, RS-422/
RS-485, Buzzer, ON/OFF, Touch (PS/2), 1 x S-Video IN, Remote External User Controls,
Alternative Keypad interface (i2c) and reserved for other signals. Custom cable lengths
can be manufactured.
• High Quality SHARP TFT
• 19.0 inch viewable image size
• Active Matrix, Thin Film Transistor (TFT)
• MVA Premium™ Technology
Sync Signal:
• Digital separate synchronisation
• Composite synchronisation
• Synchronisation on green.
• Auto detects VGA -> WUXGA, interlaced and non interlaced
• Video Signal
: Analog RGB 0,7Vp-p
: Input Impedance 75 Ohm
Synchronisation Range:
• Horizontal
: 15,0 kHz to 91,1 kHz
• Vertical
: 60 Hz* to 85 Hz
* Recommended for optimum picture quality
• 460.00 (W) x 400.00 (H) x 82.00 (D) mm
• 18.11" (W) x 15.75" (H) x 3.23" (D)
• Weight: 10 kg (approx)
• Cables
= Custom Multifunction Cable to support more signals
•
JH 19TWC STD-C1= Water Cover
•
JH 19TBR STD-B1 = Mounting Bracket
•
JH 19BRD STD-B1 = Mounting Bracket EN60945 RAL 9011
• JH MMDROSTD-A1= Rotary Bracket
•
JH 19VED STD-B1 = VESA Bracket
•
JH 19TSV STD-B1 = Sun Visor
• JH 17TAP STD-A1 = Adapter frame for 19" RACK
*Please see user manual for drawings/measurements.
• Operating
: Temperature -15 deg. C to +55 deg. C
- Humidity up to 95%
• Storage
: Temperature -20 deg. C to +60 deg. C
- Humidity up to 95%
• IP Rating
: Protection (EN60529): IP66 front - IP20 rear
• Compass Safe Dist.: JH 19T14 MMD-Mxx-Sxxx Std: 65cm Steering: 35cm
Safety Considerations:
Even although the test conditions for bridge units provide for a maximum
operating temperature of 55°C, continuous operation of all electronic
components should, if possible, take place at ambient temperatures of only
25°C. This is a necessary prerequisite for long life and low service costs.
Resolutions:
• VGA
: 640 x 480 (including 640 x 350)
• SVGA
: 800 x 600 (including 720 x 400)
• XGA
: 1024 x 768
• SXGA
: 1280 x 1024*
• UXGA
: 1600 x 1200
• WUXGA
: 1920 x 1200
* Recommended for optimum picture quality. (60 Hz only)
Video Signals (with Multifunction Cable):
• Interlaced NTSC and PAL/SECAM video
• Composite video
Multi-power Supply:
• 115&230VAC - 50/60Hz + 24 VDC
- JH 19T14 MMD-Mxx-Sxxx
Note: You may connect either AC power or DC power or both. In case both
sources are connected, power will be sourced from the AC input. If AC input
is lost, there will be a uninterrupted switch-over to DC input.
Power Consumption:
Operating
:
50W (TYP) - 60W (MAX)
• DVI-I Signal IN
: 1 x 29p DVI Female (or as RGB IN with adapter)
• RGB Signal IN
: 1 x 15p HD D-SUB (female)
• RGB Signal OUT
: 1 x 15p HD D-SUB (female) - Clone of RGB IN**
• Multifunction
: 1 x 160p D-SUB (female) - Also see table below
• USB I/O
: 1 x TYPE B Conn. (female) Reserved for future use
• AC Power IN
: 1 x Std IEC Inlet
• AC Power OUT
: 1 x Std IEC Outlet (5A Max)
• DC Power IN
: 1 x 2p D-SUB Connector (male) - Amphenol FCC17
**Tested at recommended resolutions. The RGB output signal is at same resolution and sync as the
RGB input. The output is working even if the display unit is turned off, but power cable/supply must
be connected/provided.
On front bezel - Keypad control (IP66) xxx-xxAx models:
• Power On/Off and On Screen Display Menu (push button)
• Brightness Control (up/down - push buttons)
• Hotkeys (left/right - push buttons)
• Mode Status Red/Green/Orange Illuminated LED-Ring Indicator
On front bezel - Potmeter control (IP66) xxx-xxBx models:
• Power On/Off and On Screen Display Menu (push button)
• Brightness Control (rotary control) and Hotkeys (left/right - push buttons)
• Mode Status Red/Green/Orange Illuminated LED-Ring Indicator
• Speaker / Buzzer
• Resistive* or Capacitive Touch Screen / Optical Bonding Technology*
• Color Calibrated models (ECDIS)
• Pixel Number
: 1280 x 1024
• Pixel Pitch (RGB)
: 0.294 (H) x 0.294 (V) mm
• Response Time
: 12 ms (typical), “black” to “white”
• Contrast Ratio
: 900:1 (typical)
• Light Intensity
: 300 cd/m2 (typical)
• Viewable Angle
: +/- 85 deg. (typical) (Up/Down/Left/Right)
• Active Display Area
: 376.32 (H) x 301.056 (V) mm
• Max Colors
: 16.7 millions
• JH 19T14 MMD-MA1-SAAA
= Standard, Keypad controls only
• JH 19T14 MMD-MA1-SAAC
= Standard, Capacitive Touch Screen
• JH 19T14 MMD-MA1-SOBA
= Standard, Bonded, Potmeter Controls, Buzzer
MMD-Mxx-SxBx
MMD-Mxx-SxAx
Buzzer-Potmeter-Keypad Keypad
For a full overview, please review our typenumber sheet found on our website:
http://www.hatteland-display.com/pdflink/ind100780-1.php
TFT Technology:
Synchronisation:
Physical Considerations:
T E S T I N G / A P P R O V A L S & C E R T I F I C A T E S
This product have been tested / type approved by the following classification societies: (*=pending)
IEC 60945 4th (EN 60945:2002)
ClassNK - Nippon Kaiji Kyokai
GL - Germanischer Lloyd
DNV - Det Norske Veritas
ABS - American Bureau of Shipping* BV - Bureau Veritas
CCS - China Classification Society*
LRS - Lloyd’s Register of Shipping
Available Accessories:
Environmental Considerations:
TFT Characteristics:
Supported Signals:
Typical Type Numbers:
Power Specifications:
Signal Terminals:
User Controls:
Factory Options:
*Note that all 19 inch with resistive touch screens can not be combined with bonding.
Multifunction Cable: