Lingenfelter L350080197 Lingenfelter C5 Corvette Mini Tub Kit - Manual (Page 4)

Page 3.
4. Locate the two (2) “hat” shaped brackets
shown on the left. Draw a line straight back
from each bracket so they can later be located
in the same front-to-back location. Remove
them from both sides of the vehicle. There
should be four (4) brackets removed total.
5. Lay out your lines as shown and drill the
rivets as shown.
6. Working from the trunk area measure from
the vertical wall of the fender-well towards the
center of the car, mark at 2 inches and draw a
line parallel to the fender-well.
7. Using a framing square, butt up to the
vertical wall of the fender-well and mark the
top area of the fender-well at 2.5 inches as
measured from the edge of the framing square.
Continue this line over the length of the fender-
well.