RAVE Sports Bongo 20 Bouncer Water Park - Manual (Page 4)

While looking at the appropriate diagram, locate the panel on the
diagram labeled “VALVE” and match the diagram to the inflation valve
location on your tube. This will tell you where to attach the long rope
and the short rope to the appropriate locations on the tube. The
harness will be attached to the triangular-shaped quick-link on each
anchor plate.
Ensure the triangular quick-link is completely open by rotating the
nut counter-clockwise. Attach the loop end of the rope into the quick-
link and close completely by rotating clockwise until tight.
Repeat for all rope ends.
IMPORTANT
With each anchor harness end attached to the tube, ensure the nylon
glide is free to slide smoothly along the rope(s).
Finish assembling & inflating your product, move it to the water and
attach your anchor line.
Attach anchor line to the stainless steel pivoting ring.
Attach anchor
line here
3