SkyRC e6650 User Manual
Page 23
- 22 -
This program is only suitable for charging Pb (lead-acid) battery with
nominal voltage from 2 to 20V. Pb（lead-acid）battery is completely
different from NiCd/NiMH battery. These batteries can only deliver
current lower in comparison to their capacity. The same restriction
applies to the charging process. Consequently, the optimum charge
current can only be 1/10 of the capacity. Pb battery can not be used
for fast-charging, please follow the instructions provided by the
battery manufacturer.
Due to the chemistry characteristic of Pb battery, the cut off point
may be difficult to detect sometimes. We recommend user to use
CAPACITY CUT OFF feature to protect the battery.
You can press START/ENTER key to make it blink and alter the
value of parameters using INC or DEC key, press START/ENTER
key to store the value.
CHARGING PB (LEAD-ACID) BATTERY IN THE CHARGE MODE
CHARGING PB (LEAD-ACID) BATTERY IN THE CHARGE MODE
Set up the charge current on the left and
nominal voltage on the right. Range of
discharge current is 0.1-1.0A, the voltage
should match the battery being charged.
Press START/ENTER key for more than 3
seconds to start charging.
DISCHARGING OF THE PB BATTERY
The screen displays the real-time
discharging status. Press START/ENTER
key to alter discharge current. Press
START/ENTER key again to store the
parameter value you set. Press BATT
TYPE/STOP key to end the program.
Pb DISCHARGE
1.0A 12.0V(6P)
INC
DEC
- +
INC
DEC
- +
Batt type
Stop
Start
Enter ‘>3 seconds’
Pb-6 4.0A 12.59V
DCS 022:43 00682
Battery
type
Elapsed
time
Discharge
current
Battery
voltage
Discharged
capacity