Programming alarm 2 (relay 2), Programming alarm 3 (digital output t1) – CIRCUTOR CVM-C10 Series User Manual
Page 53
Programming the contact status
The status of relay contacts is selected on this screen.
Press key
for 3 seconds to edit the selection. The
prog icon
will be displayed on the bottom of the screen.
Press key
to browse the two options:
Normally open contact.
Normally closed contact.
To validate the data, press
for 3 seconds and the
prog icon will disappear from the display.
Press key
to access the next programming step
4�9�23� Programming alarm 2 (Relay 2)
The values for alarm relay 2 are programmed on this screen.
They are programmed as in the case of alarm relay 1, see
“4.9.22. Programming alarm 1 (Relay 1)”
4�9�24� Programming alarm 3 (Digital output T1)
All values for digital output T1 are programmed on this screen.
The variable code is selected on this screen, depending on
which will control digital output T1.
Press key
for 3 seconds to edit the code selection. The
prog
icon will be displayed on the bottom of the screen.
Press key
for 3 seconds to edit the code selection. The
prog icon will be displayed on the
bottom of the screen.
To enter or modify the value, press the
key repeatedly, increasing the value of the flashing
digit.
When the desired value is shown on the screen, move onto the next digit by pressing the key
to modify the other values.
When you enter the code of a variable on the display, the symbols for that variable will be
activated.
Set the value to
00 if you do not wish to program a variable.
53
Instruction Manual
CVM-C10