CRU DX115 SAS/SATA 6G - Manual

RTX220 QR - Manual
1. Installation Steps
1.1 Frame Installation
a. Slide the DX115 frame into an open 5.25” drive bay on your computer.
b. Secure the frame to the chassis with the mounting screws provided.
c. Attach a SAS or SATA data cable to the SAS/SATA data connector on the rear of the frame.
Attach the other end to the appropriate SAS or SATA port on the computer’s motherboard.
d. Attach a Molex power connector to the rear of the receiving frame.
1.2 Hard Drive Installation
a. Push in on the ejection handle of the carrier to pop it out. Use the handle to remove the carrier
from the frame.
b. Attach a 3.5” or 2.5” hard drive to the unified power and data connector inside of the carrier.
c. With one hand on the top of the hard drive, turn the carrier over. Then secure the hard drive to
the carrier using the mounting screws provided.
1.3 Operating Your DX115
a. Slide the DX115 carrier into the frame, then push the carrier handle in until it clicks.
Data Express ™ DX115 SAS/SATA 6G Quick Start Guide
*For 6GB/s operation, a SAS or SATA 6GB/s controller and SAS or SATA 6GB/s hard drive are required.
Product Warranty
CRU-DataPort (CRU) warrants this product to be free of significant defects in material and workmanship for a period of five years from the original date of purchase.
CRU’s warranty is nontransferable and is limited to the original purchaser.
Limitation of Liability
The warranties set forth in this agreement replace all other warranties. CRU expressly disclaims all other warranties, including but not limited to, the implied war-
ranties of merchantability and fitness for a particular purpose and non-infringement of third-party rights with respect to the documentation and hardware. No CRU
dealer, agent, or employee is authorized to make any modification, extension, or addition to this warranty. In no event will CRU or its suppliers be liable for any costs
of procurement of substitute products or services, lost profits, loss of information or data, computer malfunction, or any other special, indirect, consequential, or
incidental damages arising in any way out of the sale of, use of, or inability to use any CRU product or service, even if CRU has been advised of the possibility of such
damages. In no case shall CRU’s liability exceed the actual money paid for the products at issue. CRU reserves the right to make modifications and additions to this
product without notice or taking on additional liability.
FCC Compliance Statement: “This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.”
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference when the equipment is operated in a home or commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio
communications.
In the event that you experience Radio Frequency Interference, you should take the following steps to resolve the problem:
1) Ensure that the case of your attached drive is grounded.
2) Use a data cable with RFI reducing ferrites on each end.
3) Use a power supply with an RFI reducing ferrite approximately 5 inches from the DC plug.
4) Reorient or relocate the receiving antenna.
A7-115-0006-1 Rev. 2.0
Product Name Data Express DX115 SAS/SATA 6G
Interface Types and Speeds SATA: up to 6GB/s*
SAS: up to 6GB/s*
Compatibility 2.5-inch or 3.5-inch SATA hard drives
Operating System
Requirements
• Windows 8, 7, Vista, or XP
• Windows Server 2012, 2008, and 2003 product families
• Mac OS X 10.4.x or higher
• Linux distributions that support the connection type used
Torque 2.5” hard drives, M3 screws: 4 inch-pounds max.
Compliance EMI Standard: FCC Part 15 Class B, CE
EMC Standard: EN55022, EN55024
Shipping Weight 3.8 pounts (includes accessories)
Product Dimensions 5.81” x 8.08” x 1.62” (148mm x 205mm - 41mm)
Technical Support We don’t expect anything to go wrong with your CRU product. But if it does, Tech Sup-
port is standing by and ready to help.
Contact us at www.cru-dataport.com/support . We also offer phone support at (800)
260-9800.
For the full user manual and more information about this product, please visit www.cru-dataport.com
Models Covered:
DX115 6G
FOR OFFICE OR COMMERCIAL USE