Baby Lock EmbroideryPro_BMP8_InstructionRef (BMP8) Instruction and Reference Guide - Manual (Page 207)

APPENDIX —————————————————————————————————————————————————————
190
Using the Optional Bobbin Winder
When winding the bobbin thread onto a metal bobbin, use the optional bobbin winder. The procedures for
using the optional bobbin winder are described below.
Precautions
For precautions concerning the power supply, refer to page 14.
Optional bobbin winder and its accessories
Check that the following bobbin winder and accessories are enclosed.
* The parts code of the bobbin winder set may differ depending on the area where the machine was purchased.
● Be sure to place the bobbin winder on a level, stable surface.
● Only use the bobbins supplied with this bobbin winder.
CAUTION
3
4
1
2
5
1 Main power switch
2 Bobbin winder shaft
3 Hole for thread guide
4 Hole for spool pin
5 DC input connector
6. 7. 8.
5.
1. 2. 3. 4.
9.
10.
No. Name Parts Code No. Name Parts Code
1 Bobbin winder XC6598-051 6 Power supply cord LN2284-001
2 Spool pin and holder XC5949-051 7 Metal bobbins (5) 100376-053
3 Spool cushion XA0679-050 8 Spool cap 130012-054
4 Thread guide XC6644-051 9 Weight (L) XC5974-151
5 AC adapter XC6643-051 10 Weight (S) XC6631-051