D-Link DIR-68 - Manual (Page 32)

 D-Link DIR-68 User Manual
Section  - Configuration
Check this box to enable the DHCP server on your
router. Uncheck to disable this function.
Enter the starting and ending IP addresses for the
DHCP server’s IP assignment.
Note: If you statically (manually) assign IP addresses
to your computers or devices, make sure the IP
addresses are outside of this range or you may have
an IP conflict.
The length of time for the IP address lease. Enter the
Lease time in minutes.
Enable this feature to broadcast your networks DHCP
server to LAN/WLAN clients.
NetBIOS allows LAN hosts to discover all other
computers within the network, enable this feature to
allow the DHCP Server to offer NetBIOS configuration
settings.
Enable this feature to allow WINS information to be
learned from the WAN side, disable to allow manual
configuration.
Enable DHCP
Server:
DHCP IP Address
Range:
DHCP Lease
Time:
Always
Broadcast:
NetBIOS
Announcement:
Learn NetBIOS
from WAN:
DHCP Server Settings
DHCP stands for Dynamic Host Control Protocol. The DIR-68 has a built-in DHCP server. The DHCP Server will automatically assign
an IP address to the computers on the LAN/private network. Be sure to set your computers to be DHCP clients by setting their TCP/IP
settings to “Obtain an IP Address Automatically.” When you turn your computers on, they will automatically load the proper TCP/IP
settings provided by the DIR-68. The DHCP Server will automatically allocate an unused IP address from the IP address pool to the
requesting computer. You must specify the starting and ending address of the IP address pool.