Daktronics Outdoor LED Scoreboards Installation - Manual (Page 26)

20 Electrical Installation
Radio Settings
With an All Sport radio receiver installed,
watch for the radio Broadcast settings (“b1”)
and Channel settings (“C1”) in the clock digits
or Home and Guest scores during the POST.
Scoreboards with an RC-100 base station
installed will only display the channel settings
(“CXX”, where the XX is a channel from 01-15).
Refer to Figure 21.
These values must match the settings in the
control console (refer to controller screens
below and the manual listed in Section 1.2).
If the radio receiver channel and broadcast settings do match those set in the console but the
console does not control the scoreboard, there may be radio interference. In this case, change
the settings of the wireless radio receiver inside the scoreboard and in the console as
described in the scoreboard service manual and radio control manuals.
Note: Models BA-2127, BA-2028, and BA-2029 with radio control will have two radio
receivers: one for the main scoreboard, and one for the speed of pitch digits. Both
receivers must be set to different channels.
3.6 Power/Signal Connections Between Sections
Refer to the component location drawings attached to the product specification sheets listed
in Appendix A for exact driver locations when connecting multiple scoreboard sections.
Two-Section Models
Open the appropriate access panel on the Top Section to locate the coiled bundle of
interconnect cable coming from the driver, then route and connect the cables as described
below and shown in Figure 22. Additional panels may be opened for easier access.
Route the 5-pin interconnect cable from the Top Section down into the Bottom Section, and
connect the P42 plug into the J42A jack on a Y-cable coming from the Primary Driver.
Figure 21: Radio Settings (Clock)
Figure 22: Power/Signal Connection – Two Sections, Excluding BA (Front View)
RADI O SETTI NGS
BCAST 1 CHAN 01 RADI O CHANNEL
DEFAULT: 01
All Sport Radio Settings RC-100 Radio Settings