DNF Controls 3040P-L_&_3040P-L-LT - Manual (Page 21)

3040P-L & 3040P-L-LT, Playlist Playout System, Louth Protocol Page 1 1 9 9 o o f f 2 2 4 4
LOUTH PORT Enter the controlled channel’s Louth port number (1 - 9)
on the numeric keypad. Then press the {INPUT} or
{OUTPUT} softkey. An INPUT is indicated by ‘-‘ before
the port number.
To CAPTURE (RECORD) clips, an INPUT channel must be
selected. To playout lists, an OUTPUT channel must be
selected.
Enter ‘0’, to turn off the port.
LIST MAPPING For 3040P-L, enter the number of lists desired using a
numeric keypad; the number of elements will be
automatically computed. (There will be a warning
message to unload all lists, if there are lists loaded.)
For 3040P-L-LT, List Mapping is fixed to 5x400.
STANDARD {NTSC} or {DF} or {PAL}.
WIND SPEED
{HOLD}
(Fast wind is maintained only while key is depressed.)
OR
{LATCH}
(Fast wind is initiated and maintained with momentary
key press.)
{SPEED}
Press the softkey to change the speed setting (3.9, 6.0,
8.1, 10.0, 23.7).
PREROLL VALUE Enter any number using a numeric keypad, then press
{OK} or [ENTER].
RECORD DELAY
Enter a number, up to 99, using a numeric keypad, then
press {OK} or [ENTER].
DEFAULT RECORD Enter any number using a numeric keypad, then press
{OK} or [ENTER].
EXTENDED IDs {ON} – Allow up to 32-character CLIP IDs.
{OFF} – Allow up to 8-character CLIP IDs.
PLAY PREROLL
Enter the number of frames (up to 75) that a Play
command has to be sent to the device prior to the clip
starting to play. For most servers, set it to 5 frames. For
Sony MAV-70, set it to 72 frames. For GVG servers set it
to 40 frames. Then press [ENTER] to confirm selection.