DNF Controls Tally Manager - Manual (Page 12)

Page 12 of 16
6.
Configure Monitor Wall Inputs Table
A monitor wall may be made up of multiple multi-viewer cards, each individually
controlled over an Ethernet connection. Tally Manager “sees” all of the multi-viewer
cards as one control channel, on the Device Controller. In the Protocol Assignment
Table, in the PHY CFG column, select EDIT to enter the IP addresses for each of the
cards used.
Ethernet PHY Configuration
1. Enter a unique Card Label for each card. (TSL V5 protocol requires a separate entry
for each card output.)
2. Enter the card’s IP address.
3. Enter the card’s IP address. (Consult the card manufacturer’s documentation)
4. For TSL V5 protocol only, enter the screen number. (Consult the card manufacturer’s
documentation.)