Formax 6402 Series - Manual (Page 27)

25
ENGLISH
Initially the document stoppers are adjusted for
position B. In this position a wide variety of
documents can be handled (max. 297 mm; 11.7
inch) and adjustment is not needed.
When a job is selected in which a different stopper
position has been programmed, the operator has to
put the document stoppers in the correct position as
indicated by the display.
To adjust the stopper position:
1. Lift and hold the collator arm D.
2. Squeeze the stopper and pull the front side tab
up.
To replace the stopper:
1. Place the flat back tab into the slotted hole.
2. Push the stopper into position.
Stop position A can handle documents up to 148 mm (5.8 inch), stop position B can
handle documents up to 297 mm (11.7 inch) and stop position C can handle documents
up to 356 mm (14 inch).
3.5 Loading Envelopes
3.5.1 Adjusting Side Guides
Adjust side guides C by rotating thumb wheel D, so
that the envelopes:
• Fit exactly between the side guides
• Can move freely
Note
If the distance between the side guides is too large,
the envelopes will twist sidewards, when transported
into the machine.
3.5.2 Envelope Separation
To set the envelope separation:
1. Pull down small lever A.
2. Insert one envelope up to the stoppers.
3. Return lever A.
Now the envelope separation is set.
A B C D
D C A
B
C