Formax 6402 Series - Manual (Page 40)

38
If the DFC is on you can set Continue on double on or off using the button. If
Continue on double is on (“yes”), the machine will not stop if two sheets are feeded
instead of one. The document-set containing the double sheets will be diverted.
When a job is started, the first document taken per feeder is used for a reference
measurement. When a document is exceeding that reference thickness an error will be
displayed.
Note
When Daily mail is selected, the DFC will be switched off automatically.
To set the thickness measurement:
1. Press the button to select the inserter area.
2. Press the button to switch the thickness measurement on - or off - .
If the thickness measurement is on you can set the measurement area:
3. Press the button.
4. Set the measurement area using the arrow buttons.
The standard position of the measurement area is sufficient for a great variety of
documents. Only when using special types of documents, for example small cards, the
position of the measurement area might be adjusted.
When the set thickness is not corresponding the reference value an error will be displayed.
3.9.7 Job Name
It is possible to store the job with a meaningful job
name, to easily recognize the job. This name will be
displayed in the Main screen during job selection.
1. Enter a job name using the alpha-numeric
keypad.
2. Press to clear a character left of the cursor
position (backspace).
3. Press to clear all entered characters and
start again.