Formax Cut-True 27A - Manual (Page 18)

Blade Replacement Procedure
3. Press two enable switches simultaneously to
move the blade down to the bottom position.
4. Turn the select switch to the center (OFF) posi-
tion. Using the T-wrench, remove the far right
blade screw (A).
5. Turn the select switch to the right. The blade will
move up automatically. Once fully retracted, turn
the select switch to the center (OFF) position and
turn the power OFF.
2. Turn the power switch ON, and turn the select
switch to the left.
Power switch ON
Select switch in
blade change position
Center screw
A
B C D
1. Loosen and remove (8) screws from the cover.
Remove cover.
6. Remove the far left screw (B). Remove the
screws to the left and right of center (C & D), but
leave the center screw in place.
NOTE: Do not remove the center screw.
15
Front Cover