Foxconn M7PMX Series - Manual (Page 100)

93
5
Windows Setup
You have chosen to configure a SCSI Adapter for use with Windows,
using a device support disk provided by an adapter manufacturer.
Select the SCSI Adapter you want from the following list, or press ESC
to return to the previous screen.
7. There are two drivers, all these two drivers must be installed. Press [Enter] to select
the first driver - "NVIDIA RAID Driver (required)".
8. A confirmation message apperas to double check if the driver is really what we
wanted. As we need to install both two drivers, so we will press <S> again to select
the second driver. It will ask you to insert the RAID driver diskette into your floppy
drive again, press <Enter> to continue.
ENTER=Select F3=Exit
NVIDIA nForce Storage Controller (required)
NVIDIA RAID Driver (required)
Windows Setup
Setup will load support for the following mass storage device(s):
NVIDIA RAID Driver (required)
* To specify additional SCSI adapters, CD-ROM drivers, or special
disk controllers for use with Windows, including those for
which you have a device support disk from a mass storage device
manufacturer, press S.
* If you do not have any device support disks from a mass storage
device manufacturer, or do not want to specify additional
mass storage devices for use with Windows, press ENTER.
S=Specify Additional Device ENTER=Continue F3=Exit