Foxconn M7PMX Series - Manual (Page 42)

35
3
SuperIO Devices
► OnBoard FDC Controller
This item is used to enable or disable the onboard FDC controller.
► OnBoard Serial Port 1
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard serial
port COM1.
► IR IO/IRQ Select
This item is used to assign the I/O address and interrupt request (IRQ) for the onboard infraed
chip.
► UART Mode Select
This item is used to configure COM1 port as :
[Normal] : a RS232 device. IrDA port has no function.
[irDA] : an IrDA device for maximum baud rate of 115200 bit/s. COM1 port has no function.
[ASKIR] : A faster IrDA for 1152000 bit/s. COM1 port has no function.
► IrDA Duplex Mode
This item enables you to determine the infrared function of the onboard infrared chip.
Phoenix - AwardBIOS CMOS Setup Utility
SuperIO Devices
OnBoard FDC Controller [ Enabled ] Item Help
OnBoard Serial Port 1 [3F8/IRQ4]
IR IO/IRQ Select [2F8/IRQ3] Menu Level ►
UART Mode Select [IrDA]
IrDA Duplex Mode [Half]
↑↓→←:Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Previous Values F7:Optimized Defaults
Enabled