Gasboy 1000 Series Technical Reference Manual - Manual (Page 46)

GASBOY Series 1000
2-28 03/07/03
system. All pumps are numbered consecutively beginning with the base pump
number. The maximum pump number is 99. Pump numbers that are less than
the base pump number will not be available.
Example:
If the base pump number is loaded as 3, there will not be any pumps numbered 1
or 2 at that Series 1000. When pump number 3 is selected for fueling, the first
relay in that system is activated.
Manual Entry
Standard The Manual Entry option provides an additional field that allows you to request
input from the Series 1000 user, via the keypad, during a card entry action. You
can use this field to record anything from manual oil transactions, department
numbers or trailer numbers. You can also use this field for lockout provided you
have the Dual Lockout option.
Requirements When you place your order, you must specify the field name and size as well as
whether you will use this field for lockout. The field may be up to six digits (four
digits if used for lockout). The check digit, encoded on the card, controls whether
the individual user is prompted to enter the manual entry. (For more information,
see Manual Entry Check Digit). The manual entry appears under its own
heading in the transaction printouts. Figure 2-17 shows a manual entry option
using DEPT (department number) as the entry.
CFN Network Commercial Fueling Network systems use the manual keypad entry option for a
field named JOB # which contains up to eight digits.
"A" System For matching "A" Systems, manual entry may be ordered as mandatory, rather
than regulated by a check digit.
RVÂ
Â
UEVAÂ!"#$Â
Â
VT7P 97T@ÂXAD AIR @ARV @7VAÂÂÂÂÂÂVEIAÂÂÂRÆÂRT SW7PVEVa Q@QIÂÂÂATTQTÂ
( %$#Â"(!# '%)& #" %" )"ÂÂ!#0#( ! !  !!)! $%&"!Â
) ((('Â!!"" ##$$ !! %" )"ÂÂ!#0#( # #  !   Â
!  ((''Â!!"" ##$$ !! %"!)"ÂÂ!#0#) " "  !%" Â
Â
Figure 2-17. Transaction Printout with Manual Entry Option (DEPT)
Miles/Hours Per Gallon and Reasonable Odometer/Hours Check
Description
The MPG/HPG option (which includes reasonable odometer/hours check) allows
the Series 1000 system to calculate and maintain a miles-per-gallon or hours-per-
gallon tally for a set number of vehicles (NOTE: Hours-per-gallon is used when
user equipment is monitored with an hour meter instead of an odometer). The
type of option, MPG or HPG, is chosen at the time of order. Also, the maximum
number of vehicles supported is chosen at the time of order. When specifying the
number of vehicles, the user should consider any plans for expansion of the
vehicle fleet in the future.