Gullco GK-200-RL - Manual (Page 13)

11
Manual Operation
To toggle between automatic mode (Aut) and manual mode (Hnd), place the Run/Stop switch in the
Stop position and the Fwd/Neut/Rev switch in the Rev position and press and hold the Cycle Push
Button until the desired mode is displayed (Aut or Hnd).
In manual mode (Hnd) the Auto Cycle Mode L.E.D. located in the lower right hand corner of the
display will be extinguished.
Manual mode only permits manual motion of the “KAT” carriage. The Forward/Neutral/Reverse
switch selects which direction the “KAT” will travel. The Speed Adjustment knob sets the linear
travel speed. When the Run/Stop switch is placed in the Run position, the “KAT” carriage will travel
in the direction and speed set by the Forward/Neutral/Reverse switch and the Speed Adjustment
knob. Travel motion will cease if; the Run/Stop switch is placed in the Stop position; the
Forward/Neutral/Reverse switch is placed in the Neutral position; the speed is set to zero; or the
optional travel limit switch is activated in the relevant direction (when installed).
Automatic Operation
To toggle between automatic mode (Aut) and manual mode (Hnd), place the Run/Stop switch in the
Stop position and the Fwd/Neut/Rev switch in the Rev position and press and hold the Cycle Push
Button until the desired mode is displayed (Aut or Hnd).
When the control is in automatic mode (Hnd) the Auto Cycle Mode L.E.D. located in the lower right
hand corner of the display will be constantly illuminated.
In automatic mode (Aut), the activation and subsequent procedure of an automatic cycle are
described below:
1. The automatic cycle is initiated by placing the Forward/Neutral/Reverse switch in either the
Forward or Reverse position and the Run/Stop switch in the Run position. The cycle then
proceeds to section 2.
2. Momentarily looks at the Forward/Neutral/Reverse direction switch and the optional limit
switch signals.
a. If the switch is in the Forward position and the optional forward limit switch is
activated, the cycle aborts, resets and displays “End”.
b. If the switch is in the Reverse position and the optional reverse limit switch is
activated, the cycle aborts, resets and displays “End”.
c. Otherwise the cycle proceeds to section 3.
3. Momentarily looks at the Forward/Neutral/Reverse direction switch and the Weld Direction
parameter. The setting of the Forward/Neutral/Reverse switch is ignored from this point
onward, until it is placed in the Neutral position or the Run/Stop switch is placed in the Stop
position.
a. If the switch is set to the opposite direction as the Weld Direction parameter, then the
“KAT” carriage will start to travel at full speed in the direction set by the switch until
either; the Run/Stop switch is placed in the Stop position; the