Guntermann & Drunck DiSign-System - Manual (Page 6)

2 · G&D DiSign system
Installing the DiSign system
Computer module
The CATpro2-Audio-USB computer module is connected to the computer whose
video and audio signals are to be extended and distributed. The computer module
processes the signals and transmits them via twisted pair cabling.
Connecting the computer (video and audio source)
 Monitor: Connect the 15-pin D-Sub HD plug to the VGA interface of the computer.
 USB: Connect the USB-A plug to an available USB interface of the computer.
 Speaker: Connect the jack plug to the Speaker interface of the computer.
Connection to splitter
 Transmission: Connect this interface to the Signal In interface of the DiSign-Splitter.
Use a category 5 (or better) twisted pair cabling for that purpose.
Figure 1: Legend of the CATpro2-Audio-USB computer module
NOTE: If the video and audio signals are distributed to only one display module, it
is not necessary to apply a DiSign-Splitter.
In that case, connect the Transmission interfaces of the computer module and the
display module.




2
Installation