Delta 36-714 - Manual (Page 10)

10
SETTING UP YOUR SAW
The 36-714 comes with a mobile base which can be used
by attaching the mobile base pedal as shown below. If
desired, the saw can also be bolted to the floor.
ATTACHING THE MOBILE BASE PEDAL
RISK OF PERSONAL INJURY. Two
people are needed to turn the saw over on its side.
Carefully turn the saw over on its side to gain access
to the three holes in the saw base used to attach the
mobile base pedal.
Place an M8 Flat Washer (I) Fig. 3 onto an M8x25mm
Hex Head Bolt (H) and insert through one of three
holes (A) in the mobile base pedal and through the
corresponding hole (B) of the saw base. Then, place an
M8 Flat Washer(J), an M8 Lock Washer (K) and an M8
Nut (L) on the bolt and tighten securely. Repeat this for
the other two holes and stand the saw back up again.
The mobile base pedal has two settings. It can lower
the saw onto its leveling feet for stability, or it can lift the
saw up on its wheel for mobility. The leveling feet include
adjustable locknuts for raising and lowering each foot
separately. Be sure the saw is level and will not move
during operation
Do not opoerate saw with mobile base
pedal in the down position.
BOLTING THE SAW TO FLOOR
RISK OF PERSONAL INJURY. Two
people are needed to turn the saw over on its side.
To bolt the saw to a permanent location, do not add the
mobile base pedal included with the saw. (To add the
pedal, see "ATTACHING THE MOBILE BASE PEDAL").
First, you will need to carefully turn the saw over on its
side and remove the two leveling feet and the attached
locknuts, both shown at (F) Fig. 4. Also remove two
wheels (G) by unscrewing the 5/16" Carriage Head Bolts
and 5/16" locknuts that attach them to the base.
Then, remove the nine screws which secure the dust
chute inside the saw cabinet, six of which are shown at
(C) Fig. 5. Also, remove the side panel below the motor
cover by loosening all six screws (D).
Find the holes (E) Fig. 6 in the bottom of the saw and
mark their position on the floor where you want to place
the saw. Be sure saw is on level surface. Drill pilot holes
in these spots and attach to floor using appropriate
hardware. Reassemble the dust chute and side panel.
Fig. 5
Fig. 6
C
D
E
Fig. 4
Fig. 3
A
B
F
G
L K J I H