Delta 36-714 - Manual (Page 16)

16
SAW BLADE
Disconnect machine from power source.
1. Raise the saw blade arbor to its maximum height.
Assemble the saw blade (C) Fig. 23 to the saw
arbor making sure the teeth of the blade point down
towards the front of the table, as shown in Fig. 23.
Assemble the flange (D) and arbor nut (E) to the saw
arbor and tighten arbor nut (E) as far as possible by
hand, being sure that the saw blade is against the
inner blade flange.
2. Place the open end wrench (F) Fig. 23 on the flats
on the saw arbor to keep the arbor from turning and
tighten arbor nut (E) using the remaining wrench (G)
Fig. 24, by turning the nut counterclockwise.
ALIGNING SPLITTER WITH BLADE
Disconnect machine from power source.
Use a straight edge to check to see if the saw blade (B)
is aligned with the rear of the splitter (G) in Figs. 24 and
25. If alignment is necessary, loosen the screws (A) Fig.
25A which hold the splitter bracket to the rear trunnion.
Align splitter (G) Fig. 25 with the saw blade, and tighten
two bolts (A) Fig. 25A.
Fig. 23
F
G
E
D
Fig. 24
Fig. 25
G
G
C
Fig. 25A
A
B
B