Leprecon LP-1600 Series - Manual (Page 16)

16
LP-1600 v2.83L
Run Mode
This indicates that the LP1600 has completed its power-on testing, and is
operating normally. To view channel levels being sent to the stage, turn the top
of the data wheel to the right (clockwise). The display will show channel levels
as they are being output, either in percentage-of-full or actual DMX value:
RUN 1 2 3
OUT 100 75 50
Turning the data wheel farther to the right will bring higher numbered
channels into view.
In SET-UP MODE, press the MODIFY button to select the output level mode,
then move the Wheel to the right until the menu shown below appears:
RUN Data:
>Channel DMX
The “>” points to the current display mode.
Use Wheel-Modify to move the “>” to the desired mode.
Channel data display shows the levels of the individual board channels on the
LCD and video display. In this mode, the levels mimic what is seen on the LED
indicators on the front panel. This display is unaffected by the patch tables.
DMX display mode shows the status of the DMX data being sent to the
dimmers. This information is ‘post patch’, or the actual dimmer by dimmer
data.
3.2.1. Video - Run mode
In CUE Plus models, pressing RUN will cause the Stage View screen to be
displayed on the VGA monitor: