D-Link DFL-700 - Manual (Page 22)

22
Add a new Static Route
Follow these steps to add a new route.
Step 1. Go to System and Routing.
Step 2. Click on Add new in the bottom of the routing table.
Step 3. Choose the interface that the route should be sent trough from the dropdown
menu.
Step 4. Specify the Network and Subnet mask.
Step 5. If this network is behind a remote gateway enable the checkbox Network is
behind remote gateway and specify the IP of that gateway
Click the Apply button below to apply the setting or click Cancel to discard changes.
Remove a Static Route
Follow these steps to add a remove a route.
Step 1. Go to System and Routing.
Step 2. Take Edit after the route you would like to remove.
Step 3. Check the checkbox named Delete this route.
Click the Apply button below to apply the setting or click Cancel to discard changes.