Maytag MDB6000AWA Installation - Manual (Page 6)

The door has two main springs, one located on each hinge. There are two slots on each hinge that allow
for door adjustment with the access panel removed.
To change door spring tension, use a 1/4" hex-nut driver to either loosen or tighten a single screw located
on each door spring adjustment bracket. The spring adjustment brackets are located on either side of the
dishwasher frame. These brackets stretch the springs by sliding forward and back along the dishwasher
frame.
DOOR SPRING ADJUSTMENT DOOR SPRING ADJUSTMENT
To increase spring tension: (If door falls too fast) Tighten each screw by turning clockwise.
To decrease spring tension: (If door falls too slowly) Loosen each screw by turning counterclockwise.
For heavy wood panels, an auxiliar y booster spring kit is available.
CAUTION: Disconnect electrical power before you start!
ALL ELECTRICAL WIRING AND GROUNDING
SHOULD BE DONE IN ACCORDANCE WITH
NATIONAL AND LOCAL CODES.
CAUTION: To prevent accidental contact with electrical connections,
built-in dishwasher models must not be connected to a power source
unless the dishwasher is completely enclosed, with front panels
in place. If the back or either side of the dishwasher is exposed, a
custom-made panel must be used to complete this enclosure.
CHECK LOCAL PLUMBING CODES FOR APPROVED PLUMBING
PROCEDURES AND ACCESSORIES. ALL PLUMBING SHOULD BE DONE IN
ACCORDANCE WITH NATIONAL AND LOCAL CODES.
CAUTION: Disconnect electrical power to dishwasher before you start!
This appliance must be connected to a grounded metal, permanent wiring system; or an equipment-grounding conductor
must be run with the circuit conductors and connected to the equipment-grounding terminal or lead on the appliance.
This dishwasher is designed for
operation on an adequately
wired individual 120 VAC,
60 Hz approved electrical
circuit. Use required fuse (15
amp) or comparable circuit
breaker. Two wire with ground
ser vice to the dishwasher
is recommended for connection
at the terminal box and for
grounding.
ADJUSTMENT
SCREW
Dishwaser Side View
G R O U N D I N G I N S T R U C T I O N S G R O U N D I N G I N S T R U C T I O N S
CAUTION: To prevent the possibility of electrical shock, this dishwasher, as other electrical
appliances, must be adequately grounded. It is the responsibility of the installer at the point of
installation, taking into consideration local conditions and requirements.