Maytag MDB6650AWW - Manual (Page 8)

Setting the Control Lock:
Press the pad for three seconds.
An indicator light above the pad will illuminate when
the controls are locked.
To Cancel:
Press the pad for three seconds.
The indicator light will go off.
Control Lock Option
The control touchpads can be locked to prevent unwanted
use. If this feature is activated between cycles, the dish-
washer cannot be operated until the controls are unlocked.
If desired, the controls can be locked after a cycle or delay
has started.
Note: This option does not lock the door, only the dish-
washer controls.
7
Starting The Dishwasher
After loading the dishwasher and adding detergent,
close the dishwasher by pressing the door until the
latch clicks.
To start the dishwasher, firmly press the desired
cycle and options pads. After a pause, the fill will
begin. To prevent unplanned cycle or option
changes, these selections are “locked in” after 1
minute.
The indicator lights for the selected cycle and
options will glow.
To cancel an option, press the pad again. To cancel
a cycle, press the Drain/Off pad.
Operating Tips
1
2
3
4
1
2
1
2
3
5
4
Adding a Forgotten Item
For best cleaning, the forgotten item should be added early
in the cycle.
Press the Delay/Resume pad or unlatch the door.
Wait for the water circulation to stop.
Open the door and add the item.
Close and latch the door.
• If Delay/Resume was pushed, push it again to
restart the dishwasher.
After five seconds, the cycle resumes automatically at
the point of interruption.
Note: Extended interruption of the wash cycle is not
recommended.
Delay
Resume
Controls at a Glance
(continued)
1
2
Note: If a cycle or option pad is pressed after the con-
trols have been locked, the indicator light above the
Control Lock pad will flash five times.
Note: If a cycle or option pad is pressed after the
selections are “locked in”, the indicator light above
the Control Lock pad will flash five times.